News — installation
Posted by Justin Hartenstein on
1) Begin by pulling back the inner fender liner by removing the (3) outer fasteners, unscrewing (2x) 8mm bolts and (1x) 10mm bolt. Video: https://vimeo.com/385284993 2) Now clean the painted surface of the fender with the included Isopropyl alcohol pads to remove any wax or residue that may inhibit tape bonding. 3) Using a plastic panel tool, wedge the fender vent open to route your cables. Notice the back of the light panel has a channel for the wires to exit without being pinched. 4) Once positioned peel away the red tape backing and begin to apply the panel to the fender. The...